ELEGOO Mars & Mars Pro: Replace the Touch Screen

If your Elegoo Mars or Mars Pro printer needs to replace the touch screen, please follow the steps below:

Tools you need: New Touch Screen , Pliers , and M2.0 Hex Wrench

STEPS:

Step 1: Unscrew the screws that lock the bottom shell with the 2mm Hex Wrench.

Step 2: Disassemble the bottom shell.

Step 3: Loosen the cable lock and gently unplug the cable that connects the control board and the touch screen.

Step 4: Loosen the four nuts that lock the screen with the Pliers, unscrew them with your hand, then remove the broken screen.

Step 5: Put the new screen onto the original position, lock the nuts then tighten them with the Pliers.

Step 6: Plug in the cable that connects the control board and the touch screen.

Step 7: Reassemble the bottom shell and lock the screws.

ELEGOO Mars:

ELEGOO Mars Pro: